Variflex AirZone User Manual download pdf (Page 9)

8

14

Align one of the plastic spacers with the holes

on the enclosure poles and the legs.Then,

using one of the long bolts, insert it through

the enclosure pole, the spacer and then the

leg. Secure this together with washers, and

nuts. DO NOT TIGHTEN.

16

21

22

20

24

23

15

18

19

13

Carry mesh/poles and lay on trampoline

bed with upper poles toward the center

of the trampoline (as shown above).

Select one enclosure pole and align

holes on lower section with holes on

one leg extension (F from the Parts List)

ENCLOSURE ASSEMB

L

Y

Re fer to PAR TS LIST for identication of parts.

Impo rtant: Do not use your trampoline and enclosure until you have tho rough ly read and unde rstand all instructions

and warnings provided.

17

Pull the cinch-cords at the bottom of the

enclosure together and tie very tightly.

When done correctly, this should draw

the bottom edge of the mesh tightly

under the top rail of frame.

Using the longer piece of strapping sewn

to the mesh, wrap it down, under,

and around the top rail until it comes

back out. (See steps 20, 21, & drawing “A”)

The straps should look like this when

done properly. Next, pull rmly down

on the short strap so the drawstring

returns back under the top rail.

The mesh will capture the pad cover

edging helping to secure it in place.

Tie the long and short ends into a knot.

Do this with all lower enclosure straps.

Working your way around the trampoline,

select the next enclosure pole and attach

it to the next leg extension (F), repeating

steps 14-16 until all poles are attached.

Firmly pull down pad cover edging

so that padding completely covers

top rail. Pull down into place.

Slide enclosure pole foam up and work

mesh cinch-cord down between enclosure

pole and top rail so that cinch-cord is below

top rail around the perimeter of trampoline.

Bundle the loose ends of the Enclosure

Cinch-Cord together and secure with

plastic tie. Warning - failure to do this step

may result in serious injury, strangulation or

death.

Secure all top mesh straps in tight

bowties. Then, tighten all enclosure

pole bolts and nuts. Finally, cover

exposed threads with thread protectors.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments